Help Does anybody know how to remove these screws? Need to remove them for CTB hanging

[CloseFriendofCamus]

Hello guys

Need to shift this bar to upper setting to allow more space for CTB hanging

Anyone have any idea how to remove these?

Thanks!

 

[GentleJerk]

Socket wrench.

 

[CloseFriendofCamus]

Socket wrench.
View attachment 90323

To use on BOTH sides? These two caps on my pullup bar look different from each other

 

[GentleJerk]

To use on BOTH sides? These two caps on my pullup bar look different from each other

They both look like hex nuts to me so, yep.

 

[CloseFriendofCamus]

They both look like hex nuts to me so, yep.

OK then, thank you!

How do I figure out what size of socket to use on them, though? Trial and error? One of them says 5.8, I assume it means 5.8mm?

 

[GentleJerk]

Could even use pliers to hold one while you use the socket wrench on the other if that's easier.

A socket wrench kit will come with all different size attachments like the photo.

No worries.

 

[CloseFriendofCamus]

Could even use pliers to hold one while you use the socket wrench on the other if that's easier.

A socket wrench kit will come with all different size attachments like the photo.

No worries.

Thank you once again, friend

 

[LifeHasNoOptIn]

How do I figure out what size of socket to use on them, though? Trial and error? One of them says 5.8, I assume it means 5.8mm?

Metric socket sizes are typically measured in non decimal mm sizes like 6mm, 7mm, 8mm, etc. If there is any decimal size, it would likely be x.5mm and only in smaller sizes.

 

[CloseFriendofCamus]

Metric socket sizes are typically measured in non decimal mm sizes like 6mm, 7mm, 8mm, etc. If there is any decimal size, it would likely be x.5mm and only in smaller sizes.

Oh, I see that now!